Microchip Technology TC4427EOA

Factory Lead Time

8 Weeks

Mount

Surface Mount

Mounting Type

Surface Mount

Package / Case

8-SOIC (0.154, 3.90mm Width)

Number of Pins

8

Driver Configuration

Low-Side

Logic voltage-VIL, VIH

0.8V 2.4V

Turn Off Delay Time

It is the time from when Vgs drops below 90% of the gate drive voltage to when the drain current drops below 90% of the load current. It is the delay before current starts to transition in the load, and depends on Rg. Ciss.

50 ns

Usage Level

Industrial grade

Operating Temperature

The operating temperature is the range of ambient temperature within which a power supply, or any other electrical equipment, operate in. This ranges from a minimum operating temperature, to a peak or maximum operating temperature, outside which, the power supply may fail.

-40°C~150°C TJ

Packaging

Semiconductor package is a carrier / shell used to contain and cover one or more semiconductor components or integrated circuits. The material of the shell can be metal, plastic, glass or ceramic.

Tube

Published

2003

JESD-609 Code

e3

Pbfree Code

yes

Part Status

Parts can have many statuses as they progress through the configuration, analysis, review, and approval stages.

Active

Moisture Sensitivity Level (MSL)

1 (Unlimited)

Number of Terminations

8

ECCN Code

EAR99

Resistance

12Ohm

Terminal Finish

Matte Tin (Sn) - annealed

Max Power Dissipation

The maximum power that the MOSFET can dissipate continuously under the specified thermal conditions.

470mW

Voltage - Supply

4.5V~18V

Terminal Position

DUAL

Terminal Form

Occurring at or forming the end of a series, succession, or the like; closing; concluding.

GULL WING

Peak Reflow Temperature (Cel)

260

Number of Functions

2

Time@Peak Reflow Temperature-Max (s)

40

Base Part Number

TC4427

Pin Count

a count of all of the component leads (or pins)

8

Number of Outputs

2

Output Voltage

25mV

Max Output Current

The maximum current that can be supplied to the load.

1.5A

Operating Supply Voltage

The voltage level by which an electrical system is designated and to which certain operating characteristics of the system are related.

15V

Nominal Supply Current

Nominal current is the same as the rated current. It is the current drawn by the motor while delivering rated mechanical output at its shaft.

4.5mA

Power Dissipation

the process by which an electronic or electrical device produces heat (energy loss or waste) as an undesirable derivative of its primary action.

470mW

Output Current

The rated output current is the maximum load current that a power supply can provide at a specified ambient temperature. A power supply can never provide more current that it's rated output current unless there is a fault, such as short circuit at the load.

1.5A

Max Supply Current

4.5mA

Propagation Delay

the flight time of packets over the transmission link and is limited by the speed of light.

50 ns

Input Type

Non-Inverting

Turn On Delay Time

Turn-on delay, td(on), is the time taken to charge the input capacitance of the device before drain current conduction can start.

30 ns

Max Output Voltage

The maximum output voltage refers to the dynamic area beyond which the output is saturated in the positive or negative direction, and is limited according to the load resistance value.

25mV

Rise Time

In electronics, when describing a voltage or current step function, rise time is the time taken by a signal to change from a specified low value to a specified high value.

30ns

Fall Time (Typ)

30 ns

Rise / Fall Time (Typ)

19ns 19ns

Interface IC Type

BUFFER OR INVERTER BASED MOSFET DRIVER

Channel Type

Independent

Input Bias Current

10μA

Turn On Time

The time that it takes a gate circuit to allow a current to reach its full value.

0.04 μs

Output Peak Current Limit-Nom

1.5A

Gate Type

N-Channel, P-Channel MOSFET

Current - Peak Output (Source, Sink)

1.5A 1.5A

High Side Driver

YES

Turn Off Time

0.06 μs

Height

1.42mm

Length

4.9mm

Width

3.91mm

REACH SVHC

No SVHC

Radiation Hardening

Radiation hardening is the process of making electronic components and circuits resistant to damage or malfunction caused by high levels of ionizing radiation, especially for environments in outer space (especially beyond the low Earth orbit), around nuclear reactors and particle accelerators, or during nuclear accidents or nuclear warfare.

No

RoHS Status

RoHS means “Restriction of Certain Hazardous Substances” in the “Hazardous Substances Directive” in electrical and electronic equipment.

ROHS3 Compliant

Lead Free

Lead Free