LLE101000
-
2980019-LLE101000
HONEYWELL LLE101000 SENSOR, LIQUID LEVEL, SCREW, M12
RATED voltage is the voltage on the nameplate - the "design point" for maximum power throughput and safe thermal operation.
The operating temperature is the range of ambient temperature within which a power supply, or any other electrical equipment, operate in. This ranges from a minimum operating temperature, to a peak or maximum operating temperature, outside which, the power supply may fail.
Parts can have many statuses as they progress through the configuration, analysis, review, and approval stages.
The Maximum Operating Temperature is the maximum body temperature at which the thermistor is designed to operate for extended periods of time with acceptable stability of its electrical characteristics.
Current rating is the maximum current that a fuse will carry for an indefinite period without too much deterioration of the fuse element.
In general, the absolute maximum common-mode voltage is VEE-0.3V and VCC+0.3V, but for products without a protection element at the VCC side, voltages up to the absolute maximum rated supply voltage (i.e. VEE+36V) can be supplied, regardless of supply voltage.
The minimum supply voltage (V min ) is explored for sequential logic circuits by statistically simulating the impact of within-die process variations and gate-dielectric soft breakdown on data retention and hold time.
Nominal current is the same as the rated current. It is the current drawn by the motor while delivering rated mechanical output at its shaft.
A nautical unit of measure equal to one tenth of a nautical mile or approximately 1 fathoms.
The rated output current is the maximum load current that a power supply can provide at a specified ambient temperature. A power supply can never provide more current that it's rated output current unless there is a fault, such as short circuit at the load.
the time taken for a circuit or measuring device, when subjected to a change in input signal, to change its state by a specified fraction of its total response to that change.
In electronics, when describing a voltage or current step function, rise time is the time taken by a signal to change from a specified low value to a specified high value.
RoHS means “Restriction of Certain Hazardous Substances” in the “Hazardous Substances Directive” in electrical and electronic equipment.