Maxim Integrated MAX4820EUP+

Factory Lead Time

6 Weeks

Mount

Surface Mount

Mounting Type

Surface Mount

Package / Case

20-TSSOP (0.173, 4.40mm Width) Exposed Pad

Number of Pins

20

Weight

190.990737mg

Turn Off Delay Time

It is the time from when Vgs drops below 90% of the gate drive voltage to when the drain current drops below 90% of the load current. It is the delay before current starts to transition in the load, and depends on Rg. Ciss.

1 μs

Operating Temperature

The operating temperature is the range of ambient temperature within which a power supply, or any other electrical equipment, operate in. This ranges from a minimum operating temperature, to a peak or maximum operating temperature, outside which, the power supply may fail.

-40°C~150°C TJ

Packaging

Semiconductor package is a carrier / shell used to contain and cover one or more semiconductor components or integrated circuits. The material of the shell can be metal, plastic, glass or ceramic.

Tube

Published

2010

JESD-609 Code

e3

Pbfree Code

yes

Part Status

Parts can have many statuses as they progress through the configuration, analysis, review, and approval stages.

Active

Moisture Sensitivity Level (MSL)

1 (Unlimited)

Number of Terminations

20

ECCN Code

EAR99

Resistance

2Ohm

Terminal Finish

TIN

Max Power Dissipation

The maximum power that the MOSFET can dissipate continuously under the specified thermal conditions.

1.739W

Terminal Position

DUAL

Terminal Form

Occurring at or forming the end of a series, succession, or the like; closing; concluding.

GULL WING

Peak Reflow Temperature (Cel)

260

Number of Functions

1

Supply Voltage

3.3V

Terminal Pitch

The center distance from one pole to the next.

0.65mm

Base Part Number

MAX4820

Pin Count

a count of all of the component leads (or pins)

20

Output Voltage

400mV

Output Type

N-Channel

Max Output Current

The maximum current that can be supplied to the load.

150mA

Power Supplies

an electronic circuit that converts the voltage of an alternating current (AC) into a direct current (DC) voltage.?

3.3/5V

Interface

SPI

Max Supply Voltage

In general, the absolute maximum common-mode voltage is VEE-0.3V and VCC+0.3V, but for products without a protection element at the VCC side, voltages up to the absolute maximum rated supply voltage (i.e. VEE+36V) can be supplied, regardless of supply voltage.

5.5V

Min Supply Voltage

The minimum supply voltage (V min ) is explored for sequential logic circuits by statistically simulating the impact of within-die process variations and gate-dielectric soft breakdown on data retention and hold time.

2.3V

Operating Supply Current

50μA

Output Configuration

Low Side

Output Current

The rated output current is the maximum load current that a power supply can provide at a specified ambient temperature. A power supply can never provide more current that it's rated output current unless there is a fault, such as short circuit at the load.

300mA

Turn On Delay Time

Turn-on delay, td(on), is the time taken to charge the input capacitance of the device before drain current conduction can start.

1 μs

Switch Type

Based on their characteristics, there are basically three types of switches: Linear switches, tactile switches and clicky switches.

Relay, Solenoid Driver

Output Current per Channel

70mA

Rise Time

In electronics, when describing a voltage or current step function, rise time is the time taken by a signal to change from a specified low value to a specified high value.

2μs

Fall Time (Typ)

2 μs

Ratio - Input:Output

1:8

Voltage - Load

2.3V~5.5V

Number of Drivers

8

Rds On (Typ)

2 Ω

Built-in Protections

TRANSIENT

Height

950μm

Length

6.6mm

Width

4.5mm

REACH SVHC

Unknown

Radiation Hardening

Radiation hardening is the process of making electronic components and circuits resistant to damage or malfunction caused by high levels of ionizing radiation, especially for environments in outer space (especially beyond the low Earth orbit), around nuclear reactors and particle accelerators, or during nuclear accidents or nuclear warfare.

No

RoHS Status

RoHS means “Restriction of Certain Hazardous Substances” in the “Hazardous Substances Directive” in electrical and electronic equipment.

ROHS3 Compliant

Lead Free

Lead Free