Intersil (Renesas Electronics America) CP82C88

Contact Plating

Contact plating (finish) provides corrosion protection for base metals and optimizes the mechanical and electrical properties of the contact interfaces.

Lead, Tin

Mount

Through Hole

Package / Case

DIP

Number of Pins

20

Published

1996

JESD-609 Code

e0

Pbfree Code

no

Part Status

Parts can have many statuses as they progress through the configuration, analysis, review, and approval stages.

Active

Number of Terminations

20

Terminal Finish

Tin/Lead (Sn/Pb)

Max Operating Temperature

The Maximum Operating Temperature is the maximum body temperature at which the thermistor is designed to operate for extended periods of time with acceptable stability of its electrical characteristics.

70°C

Min Operating Temperature

0°C

Terminal Position

DUAL

Peak Reflow Temperature (Cel)

NOT SPECIFIED

Supply Voltage

5V

Terminal Pitch

The center distance from one pole to the next.

2.54mm

Reach Compliance Code

not_compliant

Time@Peak Reflow Temperature-Max (s)

NOT SPECIFIED

Pin Count

a count of all of the component leads (or pins)

20

Qualification Status

An indicator of formal certification of qualifications.

Not Qualified

Operating Supply Voltage

The voltage level by which an electrical system is designated and to which certain operating characteristics of the system are related.

5V

Power Supplies

an electronic circuit that converts the voltage of an alternating current (AC) into a direct current (DC) voltage.?

5V

Temperature Grade

Temperature grades represent a tire's resistance to heat and its ability to dissipate heat when tested under controlled laboratory test conditions.

COMMERCIAL

Max Supply Voltage

In general, the absolute maximum common-mode voltage is VEE-0.3V and VCC+0.3V, but for products without a protection element at the VCC side, voltages up to the absolute maximum rated supply voltage (i.e. VEE+36V) can be supplied, regardless of supply voltage.

5.5V

Min Supply Voltage

The minimum supply voltage (V min ) is explored for sequential logic circuits by statistically simulating the impact of within-die process variations and gate-dielectric soft breakdown on data retention and hold time.

4.5V

Operating Supply Current

1mA

Nominal Supply Current

Nominal current is the same as the rated current. It is the current drawn by the motor while delivering rated mechanical output at its shaft.

1mA

uPs/uCs/Peripheral ICs Type

SYSTEM INTERFACE LOGIC, CONTROL AND COMMAND SIGNAL GENERATOR

Clock Frequency

8MHz

Bus Compatibility

80188; 80186; 8089; 80C88; 8088; 80C86; 8086

Length

25.895mm

Height Seated (Max)

5.33mm

Width

7.62mm

RoHS Status

RoHS means “Restriction of Certain Hazardous Substances” in the “Hazardous Substances Directive” in electrical and electronic equipment.

Non-RoHS Compliant

Lead Free

Contains Lead