International Rectifier IRS2128PBF

Mount

Through Hole

Package / Case

DIP

Number of Pins

8

Power Dissipation (Max)

1W

Turn Off Delay Time

It is the time from when Vgs drops below 90% of the gate drive voltage to when the drain current drops below 90% of the load current. It is the delay before current starts to transition in the load, and depends on Rg. Ciss.

150 ns

Published

2006

JESD-609 Code

e3

Pbfree Code

yes

Part Status

Parts can have many statuses as they progress through the configuration, analysis, review, and approval stages.

Active

Number of Terminations

8

ECCN Code

EAR99

Terminal Finish

Matte Tin (Sn)

Max Operating Temperature

The Maximum Operating Temperature is the maximum body temperature at which the thermistor is designed to operate for extended periods of time with acceptable stability of its electrical characteristics.

125°C

Min Operating Temperature

-40°C

Terminal Position

DUAL

Peak Reflow Temperature (Cel)

250

Number of Functions

1

Supply Voltage

15V

Terminal Pitch

The center distance from one pole to the next.

2.54mm

Time@Peak Reflow Temperature-Max (s)

30

Pin Count

a count of all of the component leads (or pins)

8

Number of Outputs

1

Max Output Current

The maximum current that can be supplied to the load.

600mA

Temperature Grade

Temperature grades represent a tire's resistance to heat and its ability to dissipate heat when tested under controlled laboratory test conditions.

AUTOMOTIVE

Max Supply Voltage

In general, the absolute maximum common-mode voltage is VEE-0.3V and VCC+0.3V, but for products without a protection element at the VCC side, voltages up to the absolute maximum rated supply voltage (i.e. VEE+36V) can be supplied, regardless of supply voltage.

20V

Min Supply Voltage

The minimum supply voltage (V min ) is explored for sequential logic circuits by statistically simulating the impact of within-die process variations and gate-dielectric soft breakdown on data retention and hold time.

10V

Nominal Supply Current

Nominal current is the same as the rated current. It is the current drawn by the motor while delivering rated mechanical output at its shaft.

120μA

Power Dissipation

the process by which an electronic or electrical device produces heat (energy loss or waste) as an undesirable derivative of its primary action.

1W

Max Supply Current

120μA

Current - Output

200mA

Propagation Delay

the flight time of packets over the transmission link and is limited by the speed of light.

200 ns

Quiescent Current

The quiescent current is defined as the current level in the amplifier when it is producing an output of zero.

60μA

Turn On Delay Time

Turn-on delay, td(on), is the time taken to charge the input capacitance of the device before drain current conduction can start.

150 ns

Rise Time

In electronics, when describing a voltage or current step function, rise time is the time taken by a signal to change from a specified low value to a specified high value.

130ns

Fall Time (Typ)

65 ns

Release Time

In telecommunication, release time is the time interval for a circuit to respond when an enabling signal is discontinued

150 ns

Interface IC Type

BUFFER OR INVERTER BASED MOSFET DRIVER

Channel Type

Single

Turn On Time

The time that it takes a gate circuit to allow a current to reach its full value.

0.2 µs

Output Peak Current Limit-Nom

0.6A

High Side Driver

YES

Turn Off Time

0.2 µs

Height

5.33mm

Length

10.92mm

Width

7.11mm

REACH SVHC

No SVHC

Radiation Hardening

Radiation hardening is the process of making electronic components and circuits resistant to damage or malfunction caused by high levels of ionizing radiation, especially for environments in outer space (especially beyond the low Earth orbit), around nuclear reactors and particle accelerators, or during nuclear accidents or nuclear warfare.

No

RoHS Status

RoHS means “Restriction of Certain Hazardous Substances” in the “Hazardous Substances Directive” in electrical and electronic equipment.

RoHS Compliant