Analog Devices 5962-8766001PA

Mount

Through Hole

Mounting Type

Through Hole

Package / Case

8-CDIP (0.300, 7.62mm)

Supplier Device Package

8-CERDIP

RoHS

Non-Compliant

Turn Off Delay Time

It is the time from when Vgs drops below 90% of the gate drive voltage to when the drain current drops below 90% of the load current. It is the delay before current starts to transition in the load, and depends on Rg. Ciss.

30 ns

Package

Tube

Base Product Number

5962-8766001

Mfr

Analog Devices Inc./Maxim Integrated

Product Status

Active

Logic voltage-VIL, VIH

0.8V, 2V

Driver Configuration

Half-Bridge

Operating Temperature

The operating temperature is the range of ambient temperature within which a power supply, or any other electrical equipment, operate in. This ranges from a minimum operating temperature, to a peak or maximum operating temperature, outside which, the power supply may fail.

-55°C ~ 125°C

Series

-

Max Operating Temperature

The Maximum Operating Temperature is the maximum body temperature at which the thermistor is designed to operate for extended periods of time with acceptable stability of its electrical characteristics.

125 °C

Min Operating Temperature

-55 °C

Max Power Dissipation

The maximum power that the MOSFET can dissipate continuously under the specified thermal conditions.

500 mW

Voltage - Supply

4.5V ~ 17V

Number of Outputs

2

Output Voltage

100 mV

Max Supply Voltage

In general, the absolute maximum common-mode voltage is VEE-0.3V and VCC+0.3V, but for products without a protection element at the VCC side, voltages up to the absolute maximum rated supply voltage (i.e. VEE+36V) can be supplied, regardless of supply voltage.

17 V

Min Supply Voltage

The minimum supply voltage (V min ) is explored for sequential logic circuits by statistically simulating the impact of within-die process variations and gate-dielectric soft breakdown on data retention and hold time.

4.5 V

Nominal Supply Current

Nominal current is the same as the rated current. It is the current drawn by the motor while delivering rated mechanical output at its shaft.

7 mA

Max Supply Current

7 mA

Input Type

Inverting

Turn On Delay Time

Turn-on delay, td(on), is the time taken to charge the input capacitance of the device before drain current conduction can start.

50 ns

Rise Time

In electronics, when describing a voltage or current step function, rise time is the time taken by a signal to change from a specified low value to a specified high value.

30 ns

Rise / Fall Time (Typ)

20ns, 20ns

Channel Type

Independent

Number of Drivers

2

Gate Type

N-Channel MOSFET

Current - Peak Output (Source, Sink)

-