Accessories

The BLUMTR-BK-FA-20 feedback cable connects the motor power and holding brake leads of an M Series servo motor to the corresponding connections of an Applied Motion servo drive.

manufacturer: Applied Motion

The YAA incremental encoder fits on the rear shafts of HT34 step motors with 3/8” diameter rear shafts. This includes the following motors:

manufacturer: Applied Motion

The 3004-263 encoder extension cable is designed for use with STM17R and STM23R integrated steppers with incremental encoders mounted to the rear shafts. This includes the following integrated stepper part numbers:

manufacturer: Applied Motion

One 3004-278 serial programming cable is required with all SWM24 drive motor models with an RS-232 port. The 3004-278 is used for setup and programming of a drive

manufacturer: Applied Motion

The 3004-190 Hub/MMI Cable is a replacement cable for SiNet Hub multi-axis controllers and MMI operator interfaces. The cable can be used to connect a SiNet Hub-compatible stepper or servo drive to one of the available ports of a SiNet Hub 444 or 8. It also cable can also be used to connect an MMI-01 or MMI-02 operator interface panel to the PC/MMI port of an Si stepper or servo drive

manufacturer: Applied Motion

The ZAA incremental encoder fits on the rear shafts of HT23 and HT24 step motors. To order the encoder factory-assembled onto the rear shaft of the motor add the ZAA suffix to the end of the double-shaft step motor part number. For example

manufacturer: Applied Motion

The MMI-02 is an easy-to-use operator interface accessory for Si Programmer™. The MMI-02 connects directly to an i or Si drive’s serial programming port and makes user access of internal Si program parameters a snap. The MMI-02 is also available in a non-backlit version

manufacturer: Applied Motion